# Making a family names Christmas tree with the Christmas Tree Names Generator

> A tree ornament made of the family's names, cut as one piece with a star on top

Each row of the tree is wider than the one above, and every name is stretched to fill its row. Sorting the names by length keeps the stretch small, so a short name sits on a narrow row and a long one on a wide row.

When most of the names are about the same length, the generator can put two short ones on one line. That gives the tree a wider base instead of a straight column.

## What you need

- 3 mm plywood or acrylic, about 100 by 140 mm
- Ribbon or thread for hanging

## 1. Type the names



Type the names under **One name per line**, up to 24 lines. To keep two names together, type them on the same line, for example Anna & Tom.

Leave **Pair short names** on. When the names alone would make a column rather than a tree, two short names share a line. Turn it off to keep one name per line.

## 2. Shape the tree



- Pick a **Font**. Bold fonts with thick strokes join best.
- Keep **Capital letters** on. Small lower case parts such as the dot of an i can end up loose, and the panel warns you when that happens.
- Set the **Width** and the **Height of the names**. The symbol and the trunk are added above and below that height.
- Raise **Line overlap** or **Letter overlap** if a letter is not joined to the tree.
- Under **Top of the tree**, keep the star or pick another **Symbol**. The **Hanging hole** goes through the symbol when there is room.

## Laser cutting

### Score and cut



1. Download the **SVG**.
2. Run the score layer first, at low power, so the edges between the letters show.
3. Cut the red outline. The whole tree comes out as one piece.
4. Thread a ribbon through the hole.

![Christmas tree of six names in maple plywood with a star on top, glued on a purple acrylic backing](https://www.mylasertools.com/tool-previews/christmas-tree-names-generator-example.webp)

Maple plywood tree glued on clear amethyst purple acrylic.

## 3D printing

### Print settings



- Download the **STL** or the **3MF**. **Thickness** sets how thick the tree is.
- Print it lying flat. The score lines are not in the 3D files, so pick a font whose letters still read when they touch.

## Make it yours

- Make one for each branch of the family, with the grandparents on the bottom line.
- Put a heart or a snowflake on top instead of the star.
- Cut it from mirror acrylic and hang it in a window.

---

Open the Christmas Tree Names Generator: https://www.mylasertools.com/christmas-tree-names-generator
Read online: https://www.mylasertools.com/learn/guides/christmas-tree-names-generator
